Carbon fiber hood camaro3/1/2024 Length of the lip is 3/8? too long or too short than the stock bumper.Īnderson Composites 6-Month Appearance Guarantee.Please note that Anderson Composites does not suggest re-installing gas trunk shocks/dampers/struts.Trunk levels more than 1/4? higher or lower than the rear fenders.Gap between the trunk and the rear fenders are more than 1/2? wide on each side.Damages to the hood that results from the absence of heat shields will not be covered under warranty. Anderson Composites requires the use of heat shields.Anderson Composites does not guarantee fitment on cars that have been in involved in accidents and/or had body damages.Damages to the hood that results from the use of gas struts will not be covered under warranty. Please note that Anderson Composites does not suggest re-installing gas hood shocks/dampers/struts.Latch is 1/16? too long or too short than the stock latch, causing the hood not to latch.Hood levels more than 1/4? higher or lower than the fenders.Gap between the hood and the fenders are more than 1/2? wide on each side.The following situations are fully covered under the Anderson Composites Fitment Guarantee: Purchases made through non-official channels do not qualify for warranties. Anderson Composites is not responsible for any damages incurred either directly or indirectly on the vehicles or operators/passengers within the vehicles.Ĭustomers in countries/regions outside of the USA should purchase Anderson Composites products from the Authorized Distributors in that region. The buyer assumes all responsibilities for determining the suitability of the products. ![]() Anderson Composites will not be held liable for anything other than the sale or exchange of said part and will not incur any other costs. Anderson Composites does not take responsibility over buyer installation, modification, and unusual stress of the products. All products are intended for off-highway uses only, and should be used for their intended purposes only. Federal and State safety crash guidelines, Anderson Composites is not responsible or liable for any damages or possible injuries incurred upon possible accidents due to driver error, incorrect installations, bad judgment, or act of nature/God, Allah, Jehovah, etc. Buyer understands that due to strict U.S. It is the buyerÆs responsibility to comply with applicable state or country laws. Items sold by Anderson Composites may not be legal for street use in all states or countries. Part Number: AC-HD1011CHCAM-CP View All CloseĪnderson Composites Terms & Conditions Warranty and Disclaimer For more information, read the freight shipping instructions. We cannot file a damage claim if the package is signed for. Please contact Phastek so we can process a replacement or refund for the product with the manufacturer. Please make sure the delivery driver notes on the shipping delivery receipt. ![]() If damaged, do NOT accept and refuse the package due to damage. Do NOT sign until you open the box first and inspect the item for damages. Slamming or dropping the hood may cause it to crack.įreight Shipping Instructions (please read before purchase): Please be sure to inspect the item before signing. Note: Always carefully close a composite hood. Anderson Composites does not suggest re-installing gas shocks, dampers, or struts. Note: The use of a hood prop rod is recommended and heat shield is required. Note: All hoods require hood pins for safety reasons. Does NOT have a provision for the OE windshield washer nozzles and hose. Note: Hood will have Center body lines that will line up with the 2010-2013 Camaro bumper, the 2014-2015 bumpers will have different bumper lines. The same heat extraction point is retained utilizing the directional components from the grille. Mounts Using OE Hardware (Not Included)Įliminate the factory hood for this Anderson Composites Type-CP hood that replicates the COPO hood design for an aggressive look.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |